Iei-integration EC-1040G Bedienungsanleitung PDF herunterladen (Seite 41)

EC-1040GB Workstation

Page 31

Step 5: Insert the appropriate number of retention screws into each side of the 5.25”

disk drive through the drive bracket (

Figure 4-7).

Figure 4-7: 5.25” Disk Drive Retention Screws (Other Side Similar)

4.5.6.2 3.5” Disk Drive in a 5.25” Slot

With the use of IEI’s 3.5” to 5.25” drive bay rack, a standard 3.5” disk drive can be installed

into a 5.25” drive bay slot. To install a 3.5” hard disk drive into a 5.25” slot of the drive

bracket, follow the instructions below.

Step 1: Slide a 3.5” disk drive into a 3.5” to 5.25” drive bay rack. Make sure the

IDE/SATA connector and the power connectors of the drive are facing the rear of

the rack.

Step 2: Insert the appropriate number of retention screws into each side of the 3.5” disk

drive through the 3.5” to 5.25” drive bay rack (Figure 4-8).

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 84 85

Keine Kommentare

Iei-integration EC-1040G Bedienungsanleitung Seite 41