Iei-integration KINO-QM57A Bedienungsanleitung PDF herunterladen (Seite 69)

KINO-QM57A Mini-ITX SBC

Page 55

The location of the AT Power Select jumper is shown in Figure 4-6 below.

Figure 4-6: AT Power Select Jumper Location

4.5.2 Clear CMOS Jumper

Jumper Label:

J_CMOS1

Jumper Type:

3-pin header (1x3)

Jumper Settings:

See

6Table 4-3

Jumper Location:

See

6Figure 4-7

If the KINO-QM57A fails to boot due to improper BIOS settings, the clear CMOS jumper

clears the CMOS data and resets the system BIOS information. To do this, use the jumper

cap to close pins 2 and 3 for a few seconds then reinstall the jumper clip back to pins 1

and 2.

If the “CMOS Settings Wrong” message is displayed during the boot up process, the fault

may be corrected by pressing the F1 to enter the CMOS Setup menu. Do one of the

following:

 Enter the correct CMOS setting

 Load Optimal Defaults

 Load Failsafe Defaults.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 163 164

Keine Kommentare

Iei-integration KINO-QM57A Bedienungsanleitung Seite 69