Iei-integration PICOe-GM45A Bedienungsanleitung PDF herunterladen (Seite 88)

PICOe-GM45A Half-Size CPU Card

Page 88

Step 3: Insert the DIMM. Once properly aligned, the DIMM can be inserted into the

socket. As the DIMM is inserted, the white handles on the side of the socket will

close automatically and secure the DIMM to the socket. See

787HFigure 5-4.

Step 4: Removing a DIMM. To remove a DIMM, push both handles outward. The

memory module is ejected by a mechanism in the socket.Step 0:

5.5 Jumper Settings

NOTE:

A jumper is a metal bridge used to close an

electrical circuit. It consists of two or three metal

pins and a small metal clip (often protected by a

plastic cover) that slides over the pins to connect

them. To CLOSE/SHORT a jumper means

connecting the pins of the jumper with the plastic

clip and to OPEN a jumper means removing the

plastic clip from a jumper.

Figure 5-5: Jumper Locations

Before the PICOe-GM45A is installed in the system, the jumpers must be set in

accordance with the desired configuration. The jumpers on the PICOe-GM45A are listed

829H788HTable 5-1.

Description Label Type

AT Power Mode Setting ATXCTL1 3-pin wafer

Clear CMOS J_CMOS1 3-pin header

LVDS Panel Resolution JP1 8-pin header

LVDS Voltage Select J_VLVDS1 3-pin header

PCIe Status Select JP2 2-pin header

Table 5-1: Jumpers

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 197 198

Keine Kommentare

Iei-integration PICOe-GM45A Bedienungsanleitung Seite 88