Iei-integration HYPER-KBN Bedienungsanleitung PDF herunterladen (Seite 52)

HYPER-KBN

Page 40

Step 3: Connect the audio devices. Connect speakers to the line-out audio jack.

Connect the output of an audio device to the line-in audio jack. Connect a

microphone to the mic-in audio jack.Step 0:

4.4.2 SATA Drive Connection

The HYPER-KBN is shipped with a SATA drive cable. To connect the SATA drive to the

connector, please follow the steps below.

Step 1: Locate the SATA connector and the SATA power connector. The locations of

the connectors are shown in Chapter 3.

Step 2: Insert the cable connector. Insert the cable connector into the on-board SATA

drive connector and the SATA power connector. See Figure 4-3.

Figure 4-3: SATA Drive Cable Connection

Step 3: Connect the cable to the SATA disk. Connect the connector on the other end

of the cable to the connector at the back of the SATA drive. See Figure 4-3.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 138 139

Keine Kommentare

Iei-integration HYPER-KBN Bedienungsanleitung Seite 52