Iei-integration ICE-945GSE v1.01 Bedienungsanleitung PDF herunterladen (Seite 51)

ICE-945GSE COM Express Type 2 Module

Page 39

5.4 Jumper Settings

NOTE:

A jumper is a metal bridge used to close an

electrical circuit. It consists of two or three

metal pins and a small metal clip (often

protected by a plastic cover) that slides over

the pins to connect them. To CLOSE/SHORT

a jumper means connecting the pins of the

jumper with the plastic clip and to OPEN a

jumper means removing the plastic clip from a

jumper.

Jumper Locations

Before the ICE-945GSE is installed in the system, the jumpers must be set in accordance

with the desired configuration. The jumpers on the ICE-945GSE are listed in

5Table 5-1

and shown in

Figure 5–2.

Description Type Label

LVDS panel resolution 4-in-1 switch SW1

BIOS selection 4-in-1 switch SW2

Table 5-1: Jumpers

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 150 151

Keine Kommentare

Iei-integration ICE-945GSE v1.01 Bedienungsanleitung Seite 51