Iei-integration NANO-9452 v4.02 Bedienungsanleitung PDF herunterladen (Seite 91)

NANO-9452 EPIC Motherboard

Page 73

Figure 5-7: CF Card Installation

5.4 Jumper Settings

NOTE:

A jumper is a metal bridge used to close an

electrical circuit. It consists of two or three metal

pins and a small metal clip (often protected by a

plastic cover) that slides over the pins to connect

them. To CLOSE/SHORT a jumper means

connecting the pins of the jumper with the plastic

clip and to OPEN a jumper means removing the

plastic clip from a jumper.

Figure 5-8: Jumper Locations

Before the NANO-9452 is installed in the system, the jumpers must be set in accordance

with the desired configuration. The jumpers on the NANO-9452 are listed in Table 5-1.

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 225 226

Keine Kommentare

Iei-integration NANO-9452 v4.02 Bedienungsanleitung Seite 91