Iei-integration SPCIE-C2060 v1.01 Bedienungsanleitung PDF herunterladen (Seite 64)

SPCIE-C2060 PICMG 1.3 CPU Card

Page 49

4.3 Jumper Settings

NOTE:

A jumper is a metal bridge used to close

an electrical circuit. It consists of two or

three metal pins and a small metal clip

(often protected by a plastic cover) that

slides over the pins to connect them. To

CLOSE/SHORT a jumper means

connecting the pins of the jumper with

the plastic clip and to OPEN a jumper means removing the plastic clip

from a jumper.

The hardware jumpers must be set before installation. Jumpers are shown in Table 4-1.

Description Label Type

AT/ATX power select JATX_AT1 2-pin header

Clear CMOS jumper J_CMOS1 3-pin header

Wake-on LAN WOL_SEL1 3-pin header

Table 4-1: Jumpers

4.3.1 AT/ATX Power Select Jumper

Jumper Label: JATX_AT1

Jumper Type:

2-pin header

Jumper Settings:

See Table 4-2

Jumper Location:

See Figure 4-7

The AT/ATX Power Select jumper specifies the systems power mode as AT or ATX.

Setting Description

Closed ATX power (Default)

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 199 200

Keine Kommentare

Iei-integration SPCIE-C2060 v1.01 Bedienungsanleitung Seite 64