Iei-integration WAFER-945GSE2 v1.03 Bedienungsanleitung Seite 79
- Seite / 204
- Inhaltsverzeichnis
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
WAFER-945GSE2 User Manual
Page 62
5.4 Jumper Settings
NOTE:
A jumper is a metal bridge used to close an
electrical circuit. It consists of two or three metal
pins and a small metal clip (often protected by a
plastic cover) that slides over the pins to connect
them. To CLOSE/SHORT a jumper means
connecting the pins of the jumper with the plastic
clip and to OPEN a jumper means removing the
plastic clip from a jumper.
Figure 5-2: Jumper Locations
Before the WAFER-945GSE2 is installed in the system, the jumpers must be set in
accordance with the desired configuration. The jumpers on the WAFER-945GSE2 are
listed in
8Table 5-1.
Description Label Type
AT/ATX power mode setting ATXCTL1 3-pin header
CF card setting JCF1 2-pin header
Clear CMOS setup J_CMOS1 3-pin header
COM2 mode setting JP1 8-pin header
LVDS1 voltage select J_VLVDS1 3-pin header
Table 5-1: Jumpers
5.4.1 AT/ATX Power Select Jumper Settings
NOTE:
The AT Power Select Jumper is the same as the ATX Enable
connector.
- WAFER-945GSE2 1
- Revision 2
- Copyright 3
- Packing List 4
- Table of Contents 5
- List of Figures 11
- List of Tables 15
- BIOS Menus 17
- 1 Introduction 18
- 1.1 Overview 19
- 1.2 WAFER-945GSE2 Overview 19
- 2 Detailed Specifications 23
- 2.1 Dimensions 24
- 2.2 Data Flow 25
- Page 10 27
- 2.3.3 Front Side Bus (FSB) 27
- Page 12 29
- 2.4.3 Intel® 945GSE Graphics 29
- 2.5 Intel 31
- ICH7-M Southbridge Chipset 31
- Page 18 35
- 2.5.5 PCI-to-ISA Bridge 35
- Page 20 37
- 2.6 LPC Bus Components 40
- Page 24 41
- 2.7.3 Power Consumption 44
- 3 Unpacking 45
- 3.1 Anti-static Precautions 46
- 3.2 Unpacking 46
- 3.3 Unpacking Checklist 47
- 4 Connectors 49
- Page 34 51
- PIN NO. DESCRIPTION 53
- 1 +5V Standby 54
- 3 PS-ON 54
- 1 Line out R 2 Line in R 55
- 3 GND 4 GND 55
- 5 Line out L 6 Line in L 55
- 7 GND 8 GND 55
- 9 Mic in 10 Mic in 55
- 1 LCD Backlight Control 56
- 2 GROUND 56
- 4 GROUND 56
- 5 BACKLIGHT Enable 56
- Page 40 57
- 3 Fan Speed Detect 59
- 7Figure 4-12 61
- 7Figure 4-13 63
- 1 Power Switch 66
- 1 Reset Switch 66
- 8Figure 4-17 67
- 8Table 4-18 67
- 1 VCC 2 GND 69
- 3 DATA- 4 DATA+ 69
- 5 DATA+ 6 DATA 69
- 7 GND 8 VCC 69
- 4.4.1 LAN Connectors 70
- 8Table 4-22 71
- 8Figure 4-20 (see 2) 71
- 8Table 4-23 and 8Figure 4-22 71
- Page 56 73
- 5 Installation 74
- 5.1 Anti-static Precautions 75
- Installation Considerations 75
- NOTE: 79
- CF Card Setup Description 81
- OFF Slave Default 81
- Short 1-2 Master 81
- Page 66 83
- 5.5 Chassis Installation 85
- Page 70 87
- 5.6.2 SATA Drive Connection 87
- 8Figure 5-9. Step 0: 88
- Page 74 91
- 5.6.5 Audio Kit Installation 91
- WARNING: 94
- Page 78 95
- Step 0: 96
- 8Figure 5-18.Step 0: 97
- 6 BIOS Screens 99
- 6.1 Introduction 100
- WAFER-945GSE2 User Manual 102
- 6.3 Advanced 103
- 6.3.1 CPU Configuration 104
- Page 88 105
- 6.3.2 IDE Configuration 105
- Page 90 107
- Page 96 113
- Page 98 115
- 6.3.5 Power Configuration 116
- Page 100 117
- 6.3.5.1 ACPI configuration 117
- Page 103 120
- 6.3.6 Remote Configuration 120
- Page 104 121
- Page 105 122
- Page 106 123
- 6.4 PCI/PnP 125
- 6.5 Boot 127
- Page 111 128
- 6.6 Security 130
- 6.7 Chipset 131
- Page 117 134
- 6.8 Exit 135
- Page 119 136
- 7 Software Drivers 137
- Page 122 139
- Page 123 140
- Page 124 141
- Page 125 142
- Page 126 143
- 7.4 VGA Driver Installation 144
- Page 128 145
- Page 129 146
- EXT to continue 147
- 7.5 LAN Driver Installation 148
- Page 132 149
- Page 133 150
- Page 134 151
- Page 135 152
- Page 136 153
- 7.7 Intel 154
- Page 138 155
- Page 139 156
- Page 140 157
- Page 141 158
- 7.8 iSMM Installation 159
- Page 143 160
- Page 144 161
- Page 145 162
- Page 146 163
- Page 147 164
- Page 148 165
- A BIOS Options 166
- B Terminology 170
- Page 154 171
- Page 155 172
- Page 156 173
- C Digital I/O Interface 174
- C.1 Introduction 175
- C.2 DIO Connector Pinouts 175
- D Watchdog Timer 177
- Page 161 178
- E Address Mapping 180
- Page 164 181
- E.2 Input/Output (IO) 182
- Page 166 183
- E.3 Interrupt Request (IRQ) 184
- E.4 Memory 185
- F Compatibility 186
- F.2 Compatible Processors 187
- Page 171 188
- G Hazardous Materials 189
- Disclosure 189
- Mercury 190
- Page 174 191
- Page 175 192
- H AC'97 Audio Codec 193
- H.1 Introduction 194
- Page 178 195
- 1038HFigure H-3) 196
- Page 181 198
- Page 182 199
Verwandte Produkte und Handbücher für Hardware Iei-integration WAFER-945GSE2 v1.03
(1 Seiten)© 2020, manymanuals.de. Alle Rechte vorbehalten. | 0.047 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern